Viewing and Configuring Radio Profiles 265

5Click Reset To Default.

6Click OK.

Configuring After you configure a radio profile, you can select the radio profile, and Advanced Radio click Properties to display a configuration wizard that contains all the Profile Settings configurable parameters for the radio profile. A dialog with the following

tabs is displayed:

„Radio Profile

„802.11 Attributes

„Auto Tune

„Service Profile Selection

„Radio Selection

„Voice Configuration

Radio Profile Tab

The Radio Profile tab lists settings for the following options:

„Name—Radio profile name

„Countermeasures Mode:

„None—Radios do not use countermeasures. This is the default.

„All—Radios use countermeasures against devices classified by MSS as rogues and against devices classified by MSS as interfering devices.

A rogue is a device that is in the 3Com network but does not belong there. An interfering device is not part of the 3Com network but also is not a rogue. MSS classifies a device as an interfering device if no client connected to the device has been detected communicating with any network entity listed in the forwarding database (FDB) of any WX switch in the Mobility Domain. Although the interfering device is not connected to your network, the device might be causing RF interference with MAP radios.

„Rogue—Radios use countermeasures against devices classified by MSS as rogues, but do not use countermeasures against devices classified by MSS as interfering devices.

Page 265
Image 265
3Com 3CRWX120695A WXR100, 3CRWXR10095A, WX4400 3CRWX440095A WX1200 manual Click Reset To Default, Radio Profile Tab