3Com 3CRWX120695A WXR100, 3CRWXR10095A, WX4400 3CRWX440095A WX1200 manual To delete an Auto DAP

Modifying Basic Switch Parameters 175

Deleting Auto DAPs 3WXM automatically updates an Auto DAP’s information in the network plan when the DAP either is converted into a configured MAP, or reboots and then connects to a different WX.

However, if an Auto DAP leaves the network without being converted into a statically configured MAP or connecting to a different WX, 3WXM continues to list the DAP as a device being managed by the WX.

In this case, you can manually delete the MAP from the WX switch’s Auto

DAP list.

This procedure does not delete an active Auto DAP. To remove an Auto DAP that is still attached to the network, remove it from the network. (Unplug it or power it down.) Then use this procedure to remove it from the Auto DAP list.

To delete an Auto DAP

1Select the Configuration tool bar option.

2In the Organizer panel, select the WX switch.

3In the Task List panel, select Delete Auto APs.

The Delete Auto APs wizard appears. The MAPs that were configured using a Distributed MAP template are listed.

4Select the Auto DAP that is no longer on the network.

5Click Next.

6Click Finish.

Launching a Telnet This option is available only if the switch is running and can be reached Management Session through the network by 3WXM Services. This option also requires the

with the Switch Managed option for the switch to be enabled. (See step 6 in “Modifying Basic Switch Parameters” on page 170.)

1Select the Configuration tool bar option.

2In the Organizer panel, select the WX switch.

3In the Task List panel, select Launch Telnet.