3Com 3CRWXR10095A manual Uploading a WX Switch into Network Plan, Click Next Click Finish

66CHAPTER 4: WORKING WITH NETWORK PLANS

5Select the scope:

„Mobility Domain

„WX switch

„Radio profile

„Individual MAP radio

To select a radio profile, display it first by clicking on the plus sign next to the WX switch. To select an individual radio, display it first by displaying its radio profile, then clicking on the plus sign next to the radio profile.

6If you accessed the wizard from the toolbar, select the scope. You can select a Mobility Domain, WX switch, MAP, or radio profile.

7Click Next. The progress is displayed.

8Click Finish.

Uploading a WX

Switch into the

Network Plan

1Select the Configuration tool bar option.

2In the Task List panel, select Upload Wireless Switch.

3In the IP Address box, type the IP address for the WX switch.

4In the Enable Password box, type the enable password for the WX switch.

This password must match the enable password that was defined using the CLI command set enablepass. For more information, see the Wireless LAN Switch and Controller Configuration Guide.

5Click Next. The uploading progress is shown.

6After the Successfully uploaded device message is displayed, click Next.

3WXM uses its verification rules to check the switch’s configuration. If an item in the configuration generates an error or warning, 3WXM displays the error or warning message.

7Review the verification messages to determine whether you will need to make changes to the switch’s configuration after uploading it into 3WXM.

8Click Next.

9Click Finish.

10If 3WXM displayed error or warning messages, select the Verification tool bar option and go to “Verifying Configuration Changes” on page 363.