
2-88 Command Line Interface Commands Reference
wireless ssid string show wireless ssid
These commands allow you to specify or show a
wireless
show wireless
These commands allow you to set, show, or turn off the wireless autochannel feature (only available for 802.11G models). Autochannel allows the Netopia Router to determine the best channel to broadcast automatically.
Three settings are available: off,
■off is the default setting; the Netopia Router will use the configured default channel.
■
■continuous performs the
Note: Channel scans can be disruptive to normal wireless activity and may take a few minutes.
wireless
Sets the wireless transmit power, scaling down the router's wireless transmit coverage by lowering its radio power output. Default is full power. Transmit power settings are useful in large venues with multiple wireless routers where you want to reuse channels. Since there are only three
show wireless clients
This command displays the connected wireless clients, if any.
Example:
#show wireless clients |
|
|
| |
Hardware Address | Status | Privacy | SSID |
|
Associated | Open | 6245 | 4521 |
48 Mbps, IP: N/A, Tx: 18485, Rx: 0 (bytes)
show wireless statistics
This command displays statistics associated with the wireless LAN.