Cisco Systems 8600 Series manual Commands, Table D-6 DIP Switch Settings

Operation

Upon power up, the system goes through power up diagnostics. The terminal displays the diagnostics sequence. Upon successful self test the unit is available for operation. The terminal will display the actual set up of the system represented by the DIP switches (see Table D-6). If the configuration was overwritten through the TTY, the terminal will display the actual set up that could be different then the dip switch setting.

Table D-6			DIP Switch Settings
1	2	3	4	5	6	7	8	9	10	11	12	1	2
0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1	0/1

Commands

Commands are entered after the user prompt. Commands are available to display the various error counters and alarms associated with the T2 line and the T3 port interface, select the source of timing for the DSU, and to enable and remove the remote loop. Table D-7lists available commands for use with the AT3-6ME terminal interface while Table D-8indicates the display format.

Table D-7	Command Summary
Command	Parameters	Meaning
?		Help Menu.
dspstat		Display status.
dspstat clear		Clears the status display
Override dipsw	0	Disable TTY configuration entry.
	1	Enable TTY configuration entry. Operates only when DIP
		switch 1-1 is down.
Sync source	0	System is slaved to the 6M line.
	1	System is slaved to the T3 line.
	2	System runs of its internal clock.
Remote loop	No of seconds	Enable remote loop back operation.
	stop	Cancel the loop back operation.

AT3-6ME Interface Adapter D-9