Cisco Systems 8600 Series manual Printer, DIP Switch Settings for Okidata

Printer

Table C-1 Control Port Parameters for Local Control (pc or workstation)

Parameter	Setting
BPX switch Port Used:	Serial CONTROL port, located on a BCC back card, is used to interface to a
	local terminal.
Code:	Standard 7 or 8-bit ASCII; 1 or 2 stop-bits; even, odd or no parity.
Interface:	RS-232 DCE.
Data Rate:	All standard asynchronous data rates from 300 to 19200 bps, independently
	software-selectable.
Supported Terminals:	Any terminal compatible with DEC VT-100.
Cable Required:	Straight-through RS-232 cable.

Printer

An optional maintenance printer for the BPX switch is the Okidata Model 184 dot matrix printer. This printer may be connected to any node. Refer to Table C-2and Table C-3for printer configuration requirements. Note that this is not the same as the printer that may be provided with the Cisco StrataView Plus NMS terminal but in addition to it.

Table C-2	Auxiliary Port Parameters for OkiData 184 Printer
Parameter		Setting
BPX switch Port Used:		Serial AUXILIARY port, located on the LM-BCC card, is used for the
		maintenance printer.
Code:		Standard 8-bit ASCII; 8 data bits, 1 stop-bit, odd parity.
Interface:		RS-232 DCE.
Data Rate:		9600 baud.
Supported Printer:		Okidata 184.
Cable Required:		Straight-through RS-232 cable

DIP Switch Settings for Okidata 184

DIP Switch A is an 8-section DIP switch located on the printer's main circuit board. Access to the configuration switches is made by sliding back the switch cover at the top, rear of the printer case. Set Switch A as indicated in Table C-3.

Table C-3	Switch A Settings—Okidata 184 Printer
Switch A	Setting	Description
1	Off	ASCII with non-slashed zero
2	Off	ASCII with non-slashed zero
3	Off	ASCII with non-slashed zero
4	Off	11-inch paper length
5	On	11-inch paper length
6	Off	No Auto Line Feed.
7	On	8-bit data.
8	Off	Enables front panel.

C-2Cisco BPX 8600 Series Reference