Cisco Systems 8600 Series DIP Switches, Table D-2 Front Panel Indicators Color Description, FT2

Equipment Description

Front Panel Indicators

The front panel of the system provides LED indicators for the alarm status of the transmit and the receive T3 and the T2 interfaces (refer to Table D-2and Figure D-2). Also on the front panel are indications for power and for operating status (Fail/Active).

The Overflow LED indicates that the cell rate coming from the T3 interface exceeds the bandwidth of the T2 facility and that the Interface Adapter buffer has overflowed.

Table D-2		Front Panel Indicators
Indicator			Color	Description
T3	Receive Status—AIS		Green	Alarm Indication signal detected on the RCV T3 line.
T3	Receive Status—RAI		Yellow	Remote Alarm Indication signal detected on the receive T3
				line.
T3	Receive Status—LOS		Red	Loss of receive T3 signal.
T3	Receive—LOF		Red	Loss of frame on receive T3 signal.
T3	Transmit Status—AIS		Green	Alarm Indication signal detected on the transmit T3 line.
T3	Transmit Status—RAI		Yellow	Remote Alarm Indication signal detected on the transmit T3
				line.
T3	Transmit Status—LOS		Red	Loss of transmit T3 signal.
T2	Receive Status—AIS		Green	Alarm Indication signal detected on the RCV T2 line.
T2	Receive Status—RAI		Yellow	Remote Alarm Indication signal detected on the receive T2
				line.
T2	Receive Status—LOS		Red	Loss of receive T2 signal.
T2	Receive—LOF		Red	Loss of frame on receive T2 signal.
T2	Transmit Status—AIS		Green	Remote Alarm Indication signal detected on the transmit T2
				line.
T2	Transmit Status—RAI		Yellow	Loss of transmit T2 signal.
T2	Transmit Status—LOS		Red	Loss of frame on transmit signal.
Overflow			Red	T3 receive cell rate exceeds the T2 line capacity.
FT2			Red	Fractional T2 indication for future use.
T3/T2 loop			Red	Indicates the unit is in loop back mode, external toward the T3
				and T2 line interfaces.
Active/Fail			Green/Red	Upon power up the system will go through extensive self tests.
				If self-test passes, the Active/Fail LED will be green; if
				self-test fails the LED will be RED.
Power			Green	Power ON indication.

DIP Switches

The adapter has two front panel DIP switches, a two-position (SW-1), and a 12-position (SW-2) switch. SW-1 controls the configurations that may interrupt operation and should be done through a two-step operation. SW-2 enables all other configuration parameters.

D-4Cisco BPX 8600 Series Reference