Cisco Systems manual 11-8Cisco BPX 8600 Series Reference

Replacing Parts

Step 6 Loosen the two captive screws on the back card faceplate and, pulling on the top and bottom card extractors, slide the card straight out of the shelf slot. (See Figure 11-2.)

To install a line module, perform the following steps:

Step 1 Insert the line module (e.g., LM-3T3) into the slot from which the defective card was removed (see Figure 11-2).

Step 2 Tighten the two captive screws. (Tighten securely, but do not overtighten.)

Step 3 Reconnect the T3 trunk cables to the LM-3T3 connectors from which they were disconnected.

Step 4 Perform the appropriate steps to bring the lines that were disconnected back on line.

11-8Cisco BPX 8600 Series Reference