Cisco Systems 8600 Series manual Dspqbin 4.1, Cnfqbin 4.1 Enable/disable e

Configuration Example

If the interfaces require other than a max PVC bandwidth of 10 Mbps or require other than a PVC LCN configuration of 256, adjust the configuration accordingly.

Step 8 For this release, Class of Service buffer 10 is used for tag switching connections. Check the queue buffer 10 configurations for port 4.1 as follows:

dspqbin 4.1 10

The qbin configuration should be as shown in the following example:

Note VC connections are grouped into large buffers called qbins. (per-VC queues can be specified on a connection-by connection basis also). In this release, all VSI connections use qbin 10 on each interface.

Sample Display:

Sample Display:
n4	TN	SuperUser	BPX 15	9.1	Apr. 4 1998 16:41 PST
Qbin Database 4.1 on BXM qbin			10
Qbin State:			Enabled
Minimum Bandwith:			0
Qbin Discard threshold:			65536
Low CLP/EPD threshold:			95%
High CLP/EPD threshold:			100%
EFCI threshold:			40%
This Command: cnfqbin 4.1 10
'E' to Enable, 'D' to Disable			[E]:

Next Command:

If the qbin is not configured as shown in the example, configure the queues on the ports using the cnfqbin command:

cnfqbin 4.1 10

enable/disable: e

For all other parameters, accept the (default).

The previous parameters can also be set for qbin 10 as follows:

cnfqbin 4.1 10 e 0 65536 95 100 40

Tag Switching 9-23