Cisco Systems 8600 Series manual Configuration Criteria, Cnfqbin Command, Cnfrsrc Command

Configuration Criteria

Configuration Criteria

Tag switching for VSIs on a BXM card is configured using the cnfrsrc and cnfqbin commands.

Qbin 10 is assigned to tag switching.

The cnfqbin Command

The cnfqbin command is used to adjust the threshold for the traffic arriving in Qbin 10 of a given

VSI interface as away of fine tuning traffic delay.

If the cnfqbin command is used to set an existing Qbin to disabled, the egress of the connection traffic to the network is disabled. Re-enabling the Qbin restores the egress traffic.

The cnfrsrc Command

The cnfrsrc command is used to enable a VSI partition and to allocate resources to the partition. An example of a cnfrsrc command is shown in the following example. If the cnfrsrc command is used to disable a partition, those connections are deleted.

n4	TN	SuperUser		BPX 15	9.1	Apr. 4 1998	16:40 PST
Port/Trunk : 4.1
Maximum PVC	LCNS:		256	Maximum PVC Bandwidth:26000
Min Lcn(1) : 0 Min Lcn(2) : 0
Partition 1
Partition State :			Enabled
Minimum VSI	LCNS:		512
Maximum VSI	LCNS:		7048
Start VSI VPI:			2
End VSI VPI	:		15
Minimum VSI	Bandwidth :		26000	Maximum VSI Bandwidth :			100000

Last Command: cnfrsrc 4.1 256 26000 1 e 512 7048 2 15 26000 100000

Next Command:

Tag Switching 9-17