Cisco Systems 8600 Series manual IPX Auto-Dial to Customer Service

Modems, Dial-In and Dial-Out

IPX Auto-Dial to Customer Service

The following is a setup procedure for the customer’s BPX to dial up customer service.

Step 1 Using the cnfterm command, set the BPX AUXILIARY port speed to 9600 bps and enable XON/XOFF flow control.

Step 2 Using the cnftermfunc command, select option 7, “Autodial Modem” and enter the customer service-designated Network ID, and the customer service modem phone number.

Step 3 Attach a 9600 bps terminal to the modem using a straight-through cable. The modem EIA port will automatically match the 9600 bps setting of the terminal.

Step 4 Enter the commands listed in either Table C-8(V.34R modem without talk/data pushbutton) or Table C-9(V.34R modem with talk/data pushbutton), to set up the modem for proper operation.

Note Consult the manual that is supplied with your modem for specific information concerning the modem configuration. Call customer service for latest modem configuration information.

Step 5 Disconnect the terminal and the straight-through cable from the IPX CONTROL port. Step 6 Connect the modem to the IPX AUX port using a null modem cable Figure C-2.Step 7 Ask customer service to assist in testing the operation of the modem setup.

Table C-8 V.34R Auto-Dial Configuration (dial-out to customer service)*

Step Command Function

These configuration commands are for a V.34R modem that does not have a talk/data pushbutton.

1.	AT&F	Initializes factory defaults.
2.	ATL1	Modem speaker at minimum volume.
3.	AT*SM3	Enables automatic MNP error correction.
4	AT*DC0	Disables data compression.
5.	AT*SC1	Enables DTE speed conversion
6.	AT*FL1	Enables XON/XOFF flow control.
7.	AT*SI1	Enables 5-minute inactivity disconnect.
8.	AT&C1	DCD controlled by modem.
9.	AT&D2	Modem disconnects when IPX toggles DTR.
10.	AT&V	Verify entries.
11.	AT&W	Saves current settings to non-volatile memory.

C-6Cisco BPX 8600 Series Reference