Cisco Systems 8600 Series Cnfrsrc Parameter Summary, Example Parameter cnfrsrc Value Description

Configuration Criteria

A detailed description of the cnfrsrc parameters is provided later in this chapter in the Command Reference section under the heading cnfrsrc. A brief summary of the parameters and their use is provided in Table 9-4.

Table 9-4	cnfrsrc Parameter Summary
		Example
Parameter (cnfrsrc)		Value	Description
slot.port		4.1	Specifies the slot and port number for the BXM
maxpvclcns		256	The maximum number of LCNs allocated for AutoRoute PVCs for this port.
maxpvcbw		26000	The maximum bandwidth of the port allocated for AutoRoute use.
partition		1	Partition number
e/d		e	enables or disables the VSI partition
minvsilcns		512	The minimum number of LCNs guaranteed for this partition.
maxvsilcns		7048	The total number of LCNs the partition is allowed for setting up connections.
			Cannot exceed the port group max shown by The dspcd command.
vsistartvpi		2	Should be set to “2” or higher for ports in trunk mode because “1” is reserved for
			AutoRoute. For ports in port mode it should be set to “1”. By default the TSC (e.g,
			7200 or 7500 series router) will use either a starting VSI VPI of 1 or 2 for tag
			switching, whichever is available. They default to 1.
vsiendvpi		15	Two VPIs are sufficient for the current release, although it may be advisable to
			reserve a larger range of VPIs for later expansion, for example, VPIs 2-15.
vsiminbw		26000	The minimum port bandwidth allocated to this partition in cells/sec. Not used in
			this release. Entered values are ignored.
vsimaxbw		100000	The maximum port bandwidth guaranteed to this partition. The actual bw may be
			as high as the line rate. This value is used for VSI QBIN bandwidth scaling.

9-18Cisco BPX 8600 Series Reference