Cisco Systems 8600 Series manual Switch Availability, Node Redundancy, Node Alarms

Switch Availability

Switch Availability

Hardware and software components are designed to provide a switch availability in excess of 99.99%. Network availability will be impacted by link failure, which has a higher probability of occurrence, than equipment failure.

Because of this, Cisco WAN network switches are designed so that connections are automatically rerouted around network trunk failures often before users detect a problem. System faults are detected and corrective action taken often before they become service affecting. The following paragraphs describe some of the features that contribute to network availability.

Node Redundancy

System availability is a primary requirement with the BPX switch. The designed availability factor of a BPX switch is (99.99%) based on a node equipped with optional redundancy and a network designed with alternate routing available. The system software, as well as firmware for each individual system module, incorporates various diagnostic and self-test routines to monitor the node for proper operation and availability of backup hardware.

For protection against hardware failure, a BPX switch shelf can be equipped with the following redundancy options:

•

•

•

•

•

•

Redundant common control modules

Redundant crosspoint switch matrixes

Redundant high-speed data and control lines

Redundant power supplies

Redundant high-speed network interface cards

Redundant service interface cards

If redundancy is provided for a BPX switch, when a hardware failure occurs, a hot-standby module is automatically switched into service, replacing the failed module. All cards are hot-pluggable, so replacing a failed card in a redundant system can be performed without disrupting service.

Since the power supplies share the power load, redundant supplies are not idle. All power supplies are active; if one fails, then the others pick up its load. The power supply subsystem is sized so that if any one supply fails, the node will continue to be supplied with adequate power to maintain normal operation of the node. The node monitors each power supply voltage output and measures cabinet temperature to be displayed on the NMS terminal or other system terminal.

Node Alarms

Each BPX switch shelf within the network runs continuous background diagnostics to verify the proper operation of all active and standby cards, backplane control, data, and clock lines, cabinet temperature, and power supplies. These background tests are transparent to normal network operation.

Each card in the node has front-panel LEDs to indicate active, failed, or standby status. Each power supply has green LEDs to indicate proper voltage input and output. An Alarm, Status, and Monitor card collects all the node hardware status conditions and reports it using front panel LED indicators and alarm closures. Indicators are provided for major alarm, minor alarm, ACO, power supply status, and alarm history. Alarm relay contact closures for major and minor alarms are available from each node through a 15-pin D-type connector for forwarding to a site alarm system.

1-24Cisco BPX 8600 Series Reference