Lucent Technologies P332MF manual Set inband vlan Command, Set inband vlan value

Chapter 6 Cajun Campus CLI – Layer 2

Set inband vlan Command

Use the set inband vlan command to set a value for the management vlan (from 1 to 3071).

The syntax for this command is:

set inband vlan <value>

value A VLAN number between 1 and 3071.

Example:

Cajun_P330-N# set inband vlan 1

Management VLAN number set to 1

Set flowcontrol Command

Use the set flowcontrol command to set the send/receive mode for flow- control frames (IEEE 802.3x or Lucent proprietary) for a full duplex port. Each direction (send or receive) can be configured separately only for Gigabit ports.

Lucent proprietary flow control cannot be configured on Gigabit ports. The set flowcontrol command cannot be used on Gigabit ports for which autonegotiation is enabled.

The syntax for this command is:

set flowcontrol {receivesendall} <mod_num>/<port_num> {onoffproprietary}

Field	Description
receive	Controls the receipt of IEEE802.3x flow-control frames on Gigabit
	ports only:
	• ON indicates that the local port will act upon flow control frames
	received from the far end
	• OFF indicates that the local port will discard flow control frames
	received from the far end
send	Controls the sending of IEEE802.3x flow-control frames from Gigabit
	ports only:
	• ON indicates that the local port is allowed to send flow control
	frames to the far end
	• OFF indicates that the local port is not allowed to send flow control
	frames to the far end

80 Cajun P332MF User’s Guide