Mitel 3000
Administrator’s Manual
OUTGOING GROUPS Outgoing groups programming when T1 is programmed
Individual T1 channels can be programmed into the different line groups.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Outgoing Groups” is displayed.
• Select “Outgoing Groups” option.
• Select the group you wish to set up. Up to 11 groups can be set up, each with a corresponding access
code, 9 or 760 - 769.
• Select the lines to be in the group.
• The menu updates to show all T1 the backup CO lines and IP Trunks equipped. The lines in the group
are indicated by a “♦”.
• Select the lines that are in the selected group. Lines 1-24 are the T1 lines programmed as equipped in
the Equipped Lines Programming and Lines 25-28 are the CO lines and IP Trunks 1- IP Trunk 12 are
VoIP lines.
In default all lines, T1 and backup CO lines are in group 1 selected by dialing 9.
VoIP lines in default are in group 2 which is selected by dialing 760.
Outgoing Groups when PRI is programmed
In this case all available B-Channels must be programmed into the same line group.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Outgoing Groups” is displayed.
• Select “Outgoing Groups” option.
• Select the group you wish to set up. Up to 11 groups can be set up, each with a corresponding access
code, 9 or 760 - 769.
• Select either the 'PRI' or the back up CO lines (Line 24 - Line 27 T1 PRI or Lines 30 – 34 if E1
programmed).
• If PRI is selected all the available B-channels are placed in the selected group.
In default the PRI and CO Lines are all in Group 1, selected by dialing 9.
VoIP lines in default are in group 2 which is selected by dialing 760.
Selecting Lines when T1 is programmed
When the option to select lines is presented the menu is updated to show all the equipped lines.
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Scroll Down and select “LCR Codes”.
• Select “LCR On” to activate the feature.
• Enter in a code index (01-50).
• Enter an input code (Up to 5 digits). Press “Confirm”. This is the code dialed by the user.
129