Mitel 3000
Administrator’s Manual
• Select the extensions to be prevented from accessing that line. A “♦” is displayed alongside those
extensions that are restricted from accessing the line, and a “◊” is displayed alongside those extensions
that have access to the line.
Press the speakerphone key to finish programming.
Note: To program Outgoing Restriction when a T1 or T1 PRI interface card is installed see page 127
To Program CO Lines to be used for Incoming Calls Only
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “Lines”.
• Press the Scroll Down key () until “Incoming Calls Only”.
• Select “Incoming Calls Only”.
• Select the lines that are to be used for incoming calls only. Lines programmed for incoming calls only
will be indicated by a “♦”.
Press the speakerphone key to finish programming.
Note: To program Incoming Calls Only when a T1 or T/E1 PRI interface card is installed see page 128.
Emergency Numbers
If the emergency number is not 911 you should program your Emergency numbers by:
• From the programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Press the Scroll Down key () until “Emergency Numbers”.
• Select “Emergency Numbers”.
• Enter the Index Number 1- 5
• Enter your Emergency numbers from your country.
Press the speakerphone key to finish programming.
Note: Default Emergency number is 911, if this is not your emergency number you need to program your
emergency numbers for the Class of service 4 to give you access to these numbers.
To Make an Internal Call
You can make an internal call in one of the following ways:
• Select the “Internal Call” option on the display and select the desired extension from the list.
• Dial the extension number (20 – 59) and select “Send Digits”.
• Lift the handset and dial the extension number.
The display will show the extension number, or, if programmed, the extension name.
From a standard analog telephone, go off-hook and dial the extension number.
To make an internal call with Automatic Line selection programmed:
1. Select the ‘Internal Call’ option on the display and select the desired extension from the list.
2. The display will show the extension number, or, if programmed, the extension’s name.
3. When dialing from a POTS phone a Hookflash is required and then dial the desired extension. This
also applies for when interrogating the voice mailbox (Hookflash + *).
35