Mocomtech CDM-QX operation manual Rne=, CC is Fault Code numbers, as in FLT? Or Infor Code, which

CDM-Qx Satellite Modem							Revision 4
Remote Control						MN/CDMQx.IOM
	Command	Arguments for						Response	Query
								to			Response to query
Parameter	(Instruction	Command or	Description of Arguments						(Instruction
								Command			(Target to
Type	Code and	Response to							Code and
								(Target to			Controller)
	qualifier)	Query							Qualifier)
								Controller)
Number of	N/A	3 bytes	Query only					N/A	NUE?	NUE=xxx
Unread Stored			Unit returns the number of stored Events, which remain							(see description of
Events			Unread, in the form of xxx.							arguments)
			Note: This means unread over the remote control.
			Example: NUE=126
Retrieve next 5	N/A	80 bytes	Query only					N/A	RNE?		RNE=
unread stored			Unit returns the oldest 5 Stored Events, which have not								{CR}ABCCddmmyyhh
Events			yet been read over the remote control. Reply format:								mmss{CR}ABCCddm
			{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-								myyhhmmss{CR}ABC
			body{CR}Sub-body{CR},	where	Sub-body	=					Cddmmyyhhmmss
			ABCCddmmyyhhmmss,								{CR}ABCCddmmyyhh
			A being the fault/clear indicator								mmss{CR}ABCCddm
			F=Fault								myyhhmmss
			C=Clear
			I =Info								(see description of
			B being the fault type where:
											arguments)
			1=Unit
			2=RX Traffic on slot#1
			3=RX Traffic on slot#2
			4=RX Traffic on slot#3
			5=RX Traffic on slot#4
			6=TX Traffic on slot#1
			7=TX Traffic on slot#2
			8=TX Traffic on slot#3
			9=TX Traffic on slot#4
			A=ODU
			B=Power ON/OFF, or log cleared

CCis Fault Code numbers, as in FLT? Or Infor Code, which

is:

0=Power Off 1=Power On 2=Log Cleared 3=Global Config Change 4=Redundancy Config Change

If there are less than 5 events to be retrieved, the remaining positions are padded with zeros.

If there are no new events, the response is RNE*.

C-34