Mocomtech CDM-QX operation manual Parameter Command Instruction Type Code Qualifier

CDM-Qx Satellite Modem		Revision 4
Remote Control		MN/CDMQx.IOM
C.5.8	Built-in BERT commands (BER Tester)

Parameter	Command
	(Instruction
Type	Code and
	Qualifier)
Built-in BERT	BST=
state (applies to
card-by-card
basis)
BERT Config	BCP=
Pattern state
(applies to card-
by-card basis)

BERT Restart	BRM=
Monitor (applies
to Rx card)
BERT 10E-3	BKE=
Error Insert
(applies to Tx
card)

Arguments

for

Command or Response to Query

1 byte, value of 0 and 1

1 byte

1byte, value of 1 only

1 byte, value of 0, 1

	Description of arguments		Response to	Query		Response to query
			Command	(Instruction
						(Target to
			(Target to	Code and
						Controller)
			Controller)	Qualifier)
Command or Query		BST=		BST?		BST=x
State of built-in tester (BST), where:		BST?			(see description of
0=Off		BST*			arguments)
1=On		BST#
		BST$
		BST^
Command or Query			BCP=	BCP?		BCP=x
Syntax: BCP=x, where x=BERT pattern			BCP?			(see description of
BERT Pattern:			BCP*			arguments)
0	= space		BCP#
1	= mark		BCP$
2	= 1:1		BCP^
3	= 1:3
4	= 63
5	= 511
6	= 2047 (default)
7	= 2047R (or 2047 Alternate)
8	= Mil 188
9	= 2^15-1
A = 2^20-1
B = 2^23-1
Command only.		BRM=		N/A	N/A
Restarts or resets the BERT monitor.		BRM?
		BRM#
Example: BRM=1		BRM$
		BRM^
		BRM@
Command or Query.			BKE=	BKE?		BKE=x
Inserts 10E-3 BER.			BKE?			(see description of
0	= Off		BKE#			arguments)
1	= On		BKE$
			BKE^
Example: BKE=1			BKE@

C-47