Mocomtech CDM-QX operation manual Img= Img?, Img#, Sno?, Snm?, Snt?, Rfo?, Bfs?, Tmp?

CDM-Qx Satellite Modem	Revision 4
Remote Control	MN/CDMQx.IOM

Parameter

Type

Command

(Instruction

Code and qualifier)

Arguments for

Command or Response to Query

Description of Arguments

Response

to

Command

(Target to

Controller)

Query

(Instruction

Code and Qualifier)

Response to query (Target to Controller)

Software Image	IMG=	1 byte, value of	Command or Query.	IMG=	IMG?	IMG=x
		1 or 2	Current active software image, where:	IMG?		(see description of
			1=Bulk Image #1 currently active	IMG*		arguments)
			2=Bulk Image #2 currently active	IMG#
				IMG^
Serial Number	N/A	9 bytes	Query only	N/A	SNO?	SNO=xxxxxxxxx
of Modulator or			Used to query the modulator or demodulator card 9-digit			(see description of
Demodulator			serial number. It returns its S/N in the form xxxxxxxxx			arguments)
Serial Number	N/A	9 bytes	Query only.	N/A	SNM?	SNM=xxxxxxxxx
of Base Unit			Used to query the 9-digit serial number of the Qx base			(see description of
			unit in the form: xxxxxxxxx			arguments)
Serial Number	N/A	9 bytes	Query only.	N/A	SNT?	SNT=xxxxxxxxx
of turbo card			Used to query the 9-digit serial number of the Turbo			(see description of
			Codec card.			arguments)
RX Frequency	N/A	6 bytes	Query Only	N/A	RFO?	RFO=sxxx.x
Offset			Unit returns the value of the measured frequency offset of			(see description of
			the carrier being demodulated, in the form sxxx.x, where:			arguments)
			xxx.x=value (range from 0 to 200 kHz, 100 Hz resolution)
			Returns +999.9 if the demodulator is unlocked
			Example: RFO=+002.3 (2.3 kHz)
Buffer Fill State	N/A	2 bytes	Query only	N/A	BFS?	BFS=xx
			Unit returns the value of the buffer fill state, between 1 to			(see description of
			99%			arguments)
			Returns 00 if demodulator is unlocked
			Example: BFS=33 (33%)
Temperature of	N/A	3 bytes	Query only	N/A	TMP?	TMP=sxx
Modulator			It returns the value of the internal card temperature, in the
			form of sxx (degrees C)			(see description of
			s=sign (+ or – character)			arguments)
			xx=value
			Example: TMP=+26

C-38