Mocomtech CDM-QX operation manual Bct= Bct?, Bct#, Bct$, Bct@, Bre?, Brr?

CDM-Qx Satellite Modem

Remote Control

	Command	Arguments
		for
Parameter	(Instruction
		Command or
Type	Code and
		Response to
	Qualifier)
		Query

	Revision 4
	MN/CDMQx.IOM
		Response to	Query	Response to query
Description of arguments		Command	(Instruction
				(Target to
		(Target to	Code and
				Controller)
		Controller)	Qualifier)

BERT Config	BCT=
Sync Loss
Threshold
(applies to Rx
card)
BERT Result in	N/A
bit errors
(applies to Rx
card)
BERT Result in	N/A
average BER

1 byte, value of 0 to 3

7bytes, numeric

5 bytes

Command or Query.		BCT=	BCT?	BCT=x
BERT config sync loss threshold.		BCT?		(see description of
0	= 256 bit errors counted in less than 1000 bits o data	BCT#		arguments)
1	= low (100 bit errors in less than 1000 bits of data)	BCT$
2	= med (250 bit errors in less than 1000 bits of data)	BCT^
3	= high (20,000 bit errors in less than 100,000 bits of data)	BCT@
Query only.		N/A	BRE?	BRE=xxxxxxx
BERT monitor results in bit errors. If bit errors exceed				(see description of
9999999, then BRE=9999999.				arguments)
Query only		N/A	BRR?	BRR=a.bEc
Returns the value of the average BER in the form a.b x 10-c.				(see description of
First 3 bytes are the value. Last 2 bytes are the exponent.				arguments)
Returns 99999 if there’s no sync in BERT monitor. Returns
99.99 if sync loss has occurred.
Example: BER=4.8E3 (BER = 4.8 x 10-3)

C-48