Mocomtech CDM-QX operation manual Esa= Esa?, Erf= Erf?, Erf#, Ira= Ira?, Ira#

CDM-Qx Satellite Modem				Revision 4
Remote Control			MN/CDMQx.IOM
	Command	Arguments		Response to	Query	Response to
Parameter	(Instruction	for Command	Description of Arguments	Command	(Instruction	query
Type	Code and	or Response		(Target to	Code and	(Target to
	qualifier)	to Query		Controller)	Qualifier)	Controller)
EDMAC Slave	ESA=	4 bytes	Command or Query	ESA=	ESA?	ESA=xxxx
Address Range			EDMAC Slave Address Range – sets the range of	ESA?		(see description of
(Modem only)			addresses of distant-end units (modems or transceivers),	ESA*		arguments)
			which this unit, as the Master, will forward, messages for.	ESA?
			Only values which are integer multiples of 10 are	ESA^
			permitted (0010, 0020, 0030, 0040, etc)
			Example: ESA=0090
			This command is only valid for an EDMAC Master. When
			used as a Query, it may be sent to an EDMAC Slave,
			which will respond with the appropriate address.
External	ERF=	1 byte, value	Command or Query	ERF=	ERF?	ERF=x
Reference		of 0 through 6	External Reference Frequency, where:	ERF?		(see description of
Frequency			0=Internal, external reference connector not used	ERF*		arguments)
			1=External 1 MHz	ERF#
			2=External 2 MHz	ERF^
			3=External 5 MHz
			4=External 10 MHz
			5=External 20 MHz
			6=Internal with 10 MHz driven to reference connector
			7=External auto detect(1,2,5,10,or 20 MHz)
			Example: ERF=0 (External reference not used, uses
			Internal)
Internal	IRA=	5 bytes,	Command or Query	IRA=	IRA?	IRA=x
Reference		numeric	Fine adjustment to the internal reference oscillator tuning	IRA?		(see description of
Oscillator			voltage, thereby, fine tuning the required internal	IRA*		arguments)
Adjust			reference frequency.	IRA#
			Syntax: IRA=sxxxx	IRA^
			Where: s = sign (- or +)
			Range: -2048 to +2047.
			Example: IRA=+0192

C-19