Mocomtech CDM-QX operation manual Flt?, =Change in fault

CDM-Qx Satellite Modem	Revision 4
Remote Control	MN/CDMQx.IOM

Parameter

Type

Command

(Instruction

Code and qualifier)

Arguments for

Command or Response to Query

Description of Arguments

Response

to

Command

(Target to

Controller)

Query

(Instruction

Code and Qualifier)

Response to query (Target to Controller)

Faults and Status

N/A	12 bytes	Query only	N/A	FLT?	FLT=abbccddeefgh
		Unit returns the current highest-prorityfault and status codes for the Unit (hardware),			(see description of
		TX Traffic, RX Traffic, and ODU in the form abcdef, where:
		a=Unit Faults:			arguments)
		0=No Faults
		1=Power Supply Fault, +5 volts			g=Change in fault
		2=Power Supply Fault, +12 volts
		3=Power Supply Fault, -5 volts			status since last poll.
		4=Power Supply Fault, +23 volts
		5=Power Supply Fault, -12 volts
		9=Ref PLL Lock			h=Change in unit
		F=EEPROM Checksum error
		6,7,8,A,B,C,D,E are reserved for future expansion			configuration since
		bb=fault codes for slot#1 can be Tx or Rx Traffic status			last poll
		cc=fault codes for slot#2 can be Tx or Rx Traffic status
		dd=fault codes for slot#3 can be Tx or Rx Traffic status
		ee=fault codes for slot#4 can be Tx or Rx Traffic status			(see description of
		TX Traffic status:
		00=TX Traffic OK			arguments)
		01=No Clock from Terrestrial Interface
		03=TX FIFO Slip
		06=TX Synthesizer Lock
		07=AUPC Upper Limit Reached
		09=AIS Detected on Incoming Data
		0B=Bipolar violation on G.703 Interface
		0F=TX EEPROM Checksum Error
		12=Power supply fault, +5 volts
		13=Power supply fault, -5 volts
		14=Power supply fault, +12 volts
		15=Power supply fault, -12 volts
		16=Power supply fault, +23 volts
		the rests are reserved for future expansion
		RX Traffic status:
		0=RX Traffic OK
		1=Demodulator Unlocked
		3=AGC Alarm – signal out of range
		5=RS Frame SYNC alarm
		7=EDMAC Frame SYNC alarm
		8=RX 1st LO Synthesizer Lock
		9=RX 2nd LO Synthesizer Lock
		A=Buffer Under
		B=Buffer Overflow
		D=Eb/No alarm
		E=AIS detected on incoming data
		F=RX EEPROM checksum error
		10=Demod FPGA not programmed
		11=Turbo FPGA not programmed
		12=Power supply fault, +5 volts
		13=Power supply fault, -5 volts
		14=Power supply fault, +12 volts
		15=Power supply fault, -12 volts
		16=Power supply fault, +23 volts
		17=QDI Deframer Unlocked
		the rests are reserved for future expansion
		f=ODU status: (for L-Band unit only)
		0=No ODU Faults
		1=BUC PLL
		3=BUC Current
		5=BUC Voltage
		7=LNB Current, 9=LNB Voltage, B=BUC Temperature, D=BUC Checksum
		C-32