Rebooting the Server and Installing the Operating System
Reinserting the Host Bus Adapter (HBA) Driver Disk
To reinsert the Host Bus Adapter (HBA) driver disk, follow these steps:
1.When prompted to reinsert the HBA driver disk you used earlier, insert the disk and press Enter. The “Setting up UnixWare” message displays. Please wait.
The “Building the Operating System” message displays. Please wait.
2.At the “UnixWare 2.1 installation is complete” prompt, remove any disk and CD.
Rebooting the System
To reboot the system, follow these steps:
1.Press Enter to reboot and restart UnixWare. If the network board(s) in your system are recognized, then the “Installing drivers for the Network Card(s)” message displays. If not, then skip to step 5, and install your driver after the OS installation is complete.
2.At the Network Interface Card Support Utility prompt, select “Accept all entries.”
3.When the system is rebuilt, you are prompted to press Enter to reboot.
4.When the “Inet Setup Values from System Files” prompt displays, enter any values where necessary (IP, DNS info., for example) and press F10 to continue. When done, select Exit.
5.When the “Language Supplement Installation” prompt displays, enter
the country information (press 
to select “United States”) and Apply. Please wait.
6.When the “Mouse Selection” prompt displays, select 3.
7. When the “Select number of mouse buttons” prompt displays, press 
to select 3 (or leave 2 if shipped with Microsoft mouse). Apply, and press Enter.
Installing UnixWare |
