SCO Release 5: Installing TCP/IP Communications
SCO Release 5: Installing TCP/IP
Communications
To install TCP/IP, follow these steps:
1.Enter Maintenance Mode (Press Enter on boot, init 1 or shutdown
2.Type “/etc/custom” and press Enter.
3.Select Software and then Install New.
4.At the “What host to install from?” prompt, press Enter.
Inserting the SMC SuperDisk
To insert the SMC SuperDisk, follow these steps:
1.When prompted to insert the media and select the media device, insert the
SMC SuperDisk for SCO UNIX into the flex drive. Verify the Media Device is set for Floppy Disk Drive 0. Press 
to get the choices for the media devices.
2.Observe the message, “Installing:
3.At the “Do you want a FULL or PARTIAL installation?” prompt, select FULL.
4.Ignore all error messages.
5.After the SMC software drivers are installed, return to the UNIX prompt.
Completing the Installation
To complete the installation, follow these steps:
1.At the # prompt type “netconfig.”
2.Select Hardware and Add New LAN Adapter.
3.Select “smpw SMC 8432, 8434 and 9332 Ethernet Adapter, board 0.”
NCR S16 Minitower Server Installing Network Operating System |
