NEC ND-71762(E) system manual General Flow of Installation Procedure, Start, Mdf, End

INSTALLATION PROCEDURE

3. INSTALLATION PROCEDURE

3.1 General Flow of Installation Procedure

This section describes installation procedure divided into installation procedure items shown in Figure 4-1. The work flow and the reference paragraphs are shown below.

	• For Digital CCIS Line
START
		Setting of switch positions and	Refer to paragraph 3.2: “Setting of Switch Positions and
		mounting of the circuit cards.	Mounting of the Circuit Cards”.
		Cable running from the PBX to the	Refer to “Cable Running from the PBX to MDF,
		MDF.	ATTCON, MAT, and SMDR” of the Installation
			Manual.
		Cable termination and cross	Refer to paragraph 3.3: “Cable Termination and Cross
		connection from the MDF to the DSU.	Connection from the MDF to the DSU”.
		Front cable connection between DTI	Refer to Figure 4-12 “Front Cable Connections between
		and CCH.	DTI/CCT and CCH”.

END

•For Analog CCIS Line

START

Setting of switch positions and mounting of the CCH card.

Cable Running from the PBX to the MODEM for Analog CCIS Line.

END

Refer to paragraph 3.2: “Setting of Switch Positions and Mounting of the Circuit Cards”.

Refer to paragraph 3.5: “Cable Running from PBX to the MODEM for Analog CCIS Line”.

CHAPTER 4 ND-71762 (E)

Page 32

Issue 2