NEC ND-71762(E) system manual PC2 LGRT1, Imx Ln

BASIC DATA ASSIGNMENT

Data Assignment of Network through FCCS Groups and NEAX7400ICS M100IMX

When CCH in the remote node is used via CCIS line, the data assignment shown below is required for inter-office service.

Example	Office Code: 76
FPC1
PC1	FCCS			Office Code: 75
IMX (NCN)	FPC2		CCIS		PC3
	PC2
		LGRT1
	IMX (LN)	CCH:00020			M100IMX
		ACC:75

In the example figure, FPC1(PC1) must be set the following data for inter-office service activated between FPC1(PC1) and PC3 (provided that CCIS data assignment is already programmed at FPC2(PC2) and PC3).

STEP 1: ADPCL - Assign PC for each speech path (Logical Route). Example: LGRT=1, PC3

STEP 2: ACSCL - Assign the location of CCH in CSCG (Common Channel Signaling Controller Group) and FPC node where accommodates CCH.

• Basic/Primary Route

CSCG	GROUP		COMMON CHANNEL SIGNALING
(2-254: even	(CIC Group	FPC		CONTROLLER LENS (CCH)
number)	No.)		MG		U	G
	0	2	00		0	20
	1	2	00		0	20
	2	2	00		0	20
2	3	2	00		0	20
	4	2	00		0	20
	5	2	00		0	20
	6	2	00		0	20
	7	2	00		0	20
• Alternate Route

CSCG	GROUP		COMMON CHANNEL SIGNALING
(2-254: odd	(CIC Group	FPC		CONTROLLER LENS (CCH)
number)	No.)		MG		U	G
	0	2	00		0	20
	1	2	00		0	20
	2	2	00		0	20
3	3	2	00		0	20
	4	2	00		0	20
	5	2	00		0	20
	6	2	00		0	20
	7	2	00		0	20

ND-71762 (E)CHAPTER 6

Page 79

Issue 2