![](/images/new-backgrounds/1148731/14873165x1.webp)
Max 410/420/430 User’s Guide – Chapter 3
Entering Static IP Addresses via HyperTerminal (Max 410)
Although many of the Max 410’s IP parameters can be set manually through the serial connection, if desired, this section will only show you how to set the IP address and netmask parameters. The procedure is as follows.
NOTE: For Max 410 units, LAN settings can only be configured by this method.
Turning DHCP On (or Off) from HyperTerminal
The Max’s default DHCP setting is DCHP enabled. Before you can enter a static IP address, you must first disable DHCP. (The same procedure is used to
1.Start your HyperTerminal connection as directed in using the HyperTerminal Emulation Program on page 18.
2.After logging in:
a.From the root directory, type NETUTIL R to move to the network utility directory.
b.From the n2p:/netutil> prompt, type dhcpd disable and then press the Enter key.
Entering an IP Address
In step 3 of Obtaining the Max’s DHCP IP Address via HyperTerminal on page 20, the menu illustrated in Figure
6 displays:
25