[Standard—Nortel Networks Confidential]
Setting DHCP parameters 79
Table 9 Setting DHCP configuration parameters
Parameter | Value | Definition | |
|
|
| |
DHCP (enable) | 1 | Yes | |
|
|
| |
DHCP (full or partial) | 1 | Partial | |
|
|
|
|
S1 | IP | <valid Server IP address> | Primary server (IP Client |
|
|
| Manager or SIP Multimedia |
|
|
| PC Client) IP address |
|
|
|
|
S1 | PORT | 5000 | Primary server port |
|
|
|
|
S1 | ACTION | 1 | Primary action code (must |
|
|
| be set to 1) |
|
|
|
|
S1 | RETRY Count | 1 | Primary retry count |
|
|
|
|
S2 | IP | <valid Server IP address> | Secondary server (IP Client |
|
|
| Manager or SIP Multimedia |
|
|
| PC Client) IP address |
|
|
| Note: If you do not know the |
|
|
| secondary IP address, use |
|
|
| the primary IP address for |
|
|
| the secondary address. |
|
|
|
|
S2 | Port | 5000 | Secondary server port |
|
|
| Note: If you do not know the |
|
|
| secondary port, use the |
|
|
| primary port. |
|
|
|
|
S2 | ACTION | 1 | Secondary action code |
|
|
| (must be set to 1) |
|
|
| |
S2 RETRY COUNT | 1 | Secondary retry count | |
|
|
| |
VLAN (0=No, 1=Yes) | 0 | QoS 802.1q VLAN Tag | |
|
|
| Service (applies to i2004 |
|
|
| with firmware version |
|
|
| xxxxB30 |
|
|
|
|
Warning: The VLAN parameter should never be selected unless the underlying network switches have been configured to filter on VLAN IDs. Otherwise, the i2004 may fail to work properly.
After pressing the Ok softkey on the last configuration parameter, you will see a message "Locating Server".
