4 Recording Images
80
Note
• HCM series cameras cannot record by sensor. You can set sensor
recording on the BL-WV10A, but sensor recording will not occur.
• If the timer is turned on after the time for which recording was to begin,
recording will begin when the timer was turned on. If the timer is turned on
after the recording was to have ended, recording will begin at the next set
interval.
• If recording start and end times conflict with previously set times, “The
timer could not be set because the recording time overlaps with another
timer. Set a different start and/or end time.“ is displayed and your settings
will be invalidated.
• Once timer recording begins, the image switches to that of the recording
camera. That image will be displayed at the resolution at which it was set
when the recording was set up. If you try to perform any operations, “Now
recording. No other operations are possible. Press [TIMER] button to stop
recording.” will be displayed.
• Timer recording will take place using the time as set on the BL-WV10A.
Be sure to confirm the current time as it is displayed, and if wrong, set the
time Date and Time screen (see page96).
• If you remove the SD memory card when the timer is on, the timer will turn
off and timer recording will not take place. Re-inserting the SD memory
card will not correct this. To do so, re-insert the SD memory card and turn
the timer on. If however, there are timer recordings set to take place
without using the SD memory card, removing the card will not turn the
timer off.
• When timer recording is set to [SENSOR], the camera lens will move to
the sensor position set for that camera (see page 59) when the sensor is
activated, and record images to the SD memory card. Local cameras will
also record images prior to and after sensor activation as well (see
page 84).
• If the power fails or is turned off during a timer recording, you may see an
error result. If that occurs, erase the timer recording settings (see
page 84).
• During timer recording , when sensor activation is used to record i mages,
the sensor indicator will begin flashing once the camera’s sensor is
activated. To stop the flashing, see page 69.
Timer/Busy indicator