2 Connecting Cameras
[For assistance, please call: 1-800-272-7033] 41
2.3.6 Placing the BB-HGW700A and the Cameras
Place cameras after confirming the camera image (see page38).
1. Turn off the BL-WV10A, BB-HGW700A, and cameras.
2. Place the BB-HGW700A and the cameras where you wish to use them.
• Refer to page6 in this manual as well as the Operating Instructions
included with the camera for proper placement.
3. Make sure the BL-WV10A is turned off.
4. Connect the LAN cables to the devices as necessary but do not turn them on.
5. Turn on the cameras connected to the BB-HGW700A.
6. Turn on the BB-HGW700A.
7. Set the mode switch on the back of the BL-WV10A to [NORMAL] and turn it
on.
8. Turn on the cameras connected to the BL-WV10A.
9. Confirm that each camera can be accessed from the BL-WV10A.
• Camera information can be displayed by pressing [DISPLAY] while
monitoring a camera. When placing a wireless camera, refer to the signal
strength displayed on-screen for optimum transmission quality.
Transmission problems can result in connection faults and problems when
monitoring the camera.
• If camera images are not smooth, repeat the procedure in this section and
try again. If the problem still persists and you are using wireless cameras,
refer to the information on page6.
Strongest signal Weakest signal No signal
Signal
strength