Panasonic Camera switch set to wired?, Same as that for the BL-WV10A?, Mode?, 152

16 Troubleshooting the BL-WV10A

Issue	Causes and Solutions
You cannot use Quick	Quick Setup will work for a maximum of 8
Setup.	cameras.
	Is the Ethernet cable connected properly?
	• If the Ethernet cable is connected properly,
	the LAN indicator will be lit green.
	Quick Setup can only be performed within 20
	minutes of turning on a camera that still has its
	default settings (as at time of purchase).
	• Turn the camera on again.
	When performing Quick Setup on the BL-C30A, is
	the camera switch set to wired?
	When performing Quick Setup on a computer for
	cameras already initialized, is the IP address the
	same as that for the BL-WV10A?
No router is displayed,	Was the router turned on before the BL-WV10A?
even though one is	• Turn the router on and wait a minute or more
connected.
	before turning the BL-WV10A on.
	Is the DHCP server option in the router settings
	turned off?
	• Quick Setup cannot be performed.Launch the
	BL-WV10A in normal mode, and manually
	perform network settings from the Setup
	menu.
Display indicates no	This appears when the BB-HGW700A is not
wireless router.	connected.
	• Each device is initialized with different
	wireless data settings, but can be used as is.
	Are the wireless settings for the BB-HGW700A
	configured to not use wireless options?
Display indicates that no	Are the wireless settings for the BB-HGW700A
wireless router was found.	configured for the 802.11a communications
	mode?
	• If the BL-WV10A is used as a repeater, use a
	communications mode other than 802.11a for
	the BB-HGW700A. If the BL-WV10A is used
	as an access point, launch in normal mode,
	and then manually input the settings in the
	Wireless section of the Setup menu.

152