10 Adding Cameras

10 Adding Cameras

For BL-C10A and BL-C30A users, the camera’s firmware must be version 1.22 or higher in order to function properly with the BL-WV10A.

For HCM series camera users, the camera’s firmware must be version 1.08 or higher in order to function properly with the BL-WV10A.

For the latest firmware, visit http://panasonic.co.jp/pcc/products/en/netwkcam/ Refer to the Operating Instructions included with your camera for information on confirming the firmware version of your camera.

Cameras already configured cannot use Quick Setup to become local cameras.

Reset the camera to its default settings and perform Quick Setup (see page 20). A maximum of 8 cameras can be connected.

1.Set the mode switch on the back on the BL-WV10A to [SETUP], turn the BL- WV10A off and then turn it back on again.

When connecting to the Panasonic camera control unit, BB-HGW700A, connect the BB-HGW700A to one of the LAN jacks on the BL-WV10A before turning either the BB-HGW700A or the BL-WV10A on.

2.Using the Ethernet cable that came with the camera, connect it to one of the 4 LAN jacks on the BL-WV10A and then turn the camera on.

When connecting a camera to the BB-HGW700A, do so after confirming that the BB-HGW700A is already connected to the BL-WV10A.

Quick Setup will begin for the camera.

Rear panel of

BL-WV10A

LAN jacks

Ethernet cable

Switch

Bottom of BL-C30A

To configure a BL-

Rear of camera C30A wireless camera using the

Quick Setup utility, set the switch on the bottom of the camera to [WIRED]

132

Page 132
Image 132
Panasonic BL-WV10A operating instructions Adding Cameras, Quick Setup will begin for the camera Rear panel