Panasonic BL-WV10A Security code must be 4 digits in length, Network Settings

6 Setup Menu

Note

•If you forget the security code, you will be unable to enter the Setup screen, and you will need to reset the BL-WV10A. Doing so, however, will reset all of your settings to their defaults, and sever the connections to the cameras. If necessary, write down the security code and store it in a secure place.

•The security code must be 4 digits in length.

•If you forget the security code, push the FACTORY DEFAULT RESET button to restore the BL-WV10A's default settings (see page 131). You will need to re- perform Quick Setup to register the cameras and set desired settings again.

•Setting the volume to off will turn off both the buzzer and any operational sounds.

•To turn off the volume for the buzzer in Sensor Alert mode only, press [ALERT].

Network Settings

Change the settings for the BL-WV10A's network information.

Setting	Description
IP Address/	Set the IP address and subnet mask for the BL-WV10A.
Subnet Mask
Gateway	Set the gateway address
DNS1/DNS2	Set the IP address for the DNS server.
	Up to 2 DNS server addresses can be set.
Proxy Server/	If you will use a proxy server to view camera images, enter its
Proxy Port	name and port number here.

Note

•If the BL-WV10A will not be connected to a network (the BL-WV10A will only be connected to cameras), these settings can be ignored.

[For assistance, please call: 1-800-272-7033] 99