15 Error Messages

Error Message

Causes and Solutions

 

 

The timer could not be set

This error is displayed if the start and end times

because the recording

during Timer Recording Setup are identical.

start and end time are the

• There must be a difference of at least one

same. Set a different start

minute between start and end times.

or end time.

 

 

 

The timer could not be set

This error is displayed during Timer Recording

because the recording

Setup if the day and time are identical to those of

time overlaps with another

a previously set timer recording.

timer. Set a different start

• Reset using different specifications for the

and/or end time.

recording.

 

 

 

To use the sensor,

This error appears if the ID and password

first enter the

required for sensor use for remote cameras are

Administrator

different than those of the administrator.

user name and password

• Enter the administrator name and password

on this camera's [User

in the [User Info] screen.

Info] screen.

 

 

 

No camera name entered.

This error appears when either the Image

 

Confirm or Register button is pressed before

 

entering a camera name when newly registering

 

remote cameras.

 

• Enter a camera name.

 

 

The IP address and port

This error appears when either the Image

are not set.

Confirm or Register button is pressed before

 

entering a camera address when newly

 

registering remote cameras.

 

• Enter a camera address.

 

 

There was a recording

This error appears if for some reason, during

error.

standard recording, the signal from a camera is

 

lost.

 

• Make sure camera monitoring is possible,

 

then try recording again.

 

 

142

Page 142
Image 142
Panasonic BL-WV10A This error is displayed if the start and end times, This error is displayed during Timer Recording