Connecting the LAN Cable, Telephone Line Cable and Power Cord

Power Cord

Plug one end of the power cord into an ordinary 3 prong AC outlet and the other end into the receptacle on the rear of the machine.

Note:

1.Make sure that the LAN Cable is plugged into the RJ-45 LAN Jack before applying power to the machine.

2.If the Dynamic Host Configuration Protocol (DHCP) is not available, an Information Code 722 will appear on the Display. Please refer to the Information Codes table on page 228 for additional information.

Warning: This apparatus must be properly grounded through an ordinary 3 prong AC outlet. Do not break off the earth (ground) prong to fit a 2 prong outlet.

Power Cord (Included)

Telephone Line Cable

Plug one end of the telephone line cable into the "RJ-11C" telephone jack supplied by the telephone company and the other end into the LINE jack on the left side of the machine.

RJ-11C Telephone Jack

Telephone Line Cable (Included)

Ethernet LAN Cable

Ethernet-Token-Ring Bridge

(Optional Order No. UE-204006)

 

Ethernet LAN (10Base-T/100Base-TX)

10Base-T/100Base-TX Ethernet Hub

Cable (Not included)

NOTE

1.Your machine uses little power and you should keep it ON at all times. If the power is turned OFF for too long, the clock contents may be lost.

40

Page 40
Image 40
Panasonic DX-800 appendix Power Cord, Telephone Line Cable, Ethernet LAN Cable