To exit an option without changing the setting, press Escape/Clear.

S u p p l y Ty p e

You can print on aperture, black mark, die cut, or continuous supplies. You have to tell the printer which supplies you are using.

If you are using edge aperture supplies, use the die cut setting. If you are using center aperture supplies, use the aperture setting.

To change the setting, from the Main Menu, select Setup, then Supply. If password protection in enabled, press Feed/Cut three times, then press Enter/Pause before you see the Setup Menu options. Then, follow these steps.

1.Press l or r until you see

SUPPLY

l Supply Type r

2.Press Enter/Pause to set the supply type option. The current setting is displayed, for example:

 

SUPPLY TYPE

 

l

Black Mark

r

3.Press l or r to see the other options. After you display the option you want, press Enter/Pause. Press Escape/Clear until you see the Main Menu.

4-2Setting Supply Options

Page 40
Image 40
Paxar 9855 manual P p l y Ty p e, Supply