
R e s e t t o D e f a u l t Va l u e s
To change the setting, from the Main Menu select Setup, Port Settings, then Serial Comm. Then, follow these steps.
1.Press r until you see
SERIAL COMM
lReset
2.Press Enter/Pause.
Are you sure?
No r
3.Press l or r to make your selection, then press Enter/Pause. If you select "Yes," the following defaults are restored: 9600 baud, No parity, 8 bit word length, and 1 stop bit. Press Escape/Clear until you see the Main Menu.
P a r a l l e l C o m m u n i c a t i o n s
The parallel communications menu allows you to set the values for the active parallel port. The values are listed in the table below.
Option | Choices | Default |
|
|
|
Port | External/Internal | External |
|
|
|
Mode | Compatible | |
|
| (Centronics mode) |
P o r t
To change the setting, from the Main Menu select Setup, Port Settings, then Parallel Comm. Then, follow these steps.
Communication Values