Premier Mounts CDM-600 Tip= Tip?, Tip#, Rfq= Rfq?, Rfq#, Rit= Rit?, Rit#

CDM-600 Satellite Modem											Revision 7
Remote Control											MN/CDM600.IOM
Parameter		Command		Arguments			Response		Query
		(Instruction		for Command					(Instruction
						Description of Arguments	to				Response to Query
Type		Code and		or Response					Code and
							Command
		Qualifier)		to Query					Qualifier)
Tx IF		TIP=		1 byte, value		Command or Query.		TIP=	TIP?		TIP=x
Impedance				of 5 or 7		Tx IF Impedance, where:		TIP?			(see description of
						Ω		TIP*			arguments)
					5=50
						Ω		TIP#
					7=75
						Both Tx and Rx sides will change with this selection.
						Example: TIP=5 (50Ω)
Rx Frequency	RFQ=		8 bytes		Command or Query.			RFQ=	RFQ?	RFQ=xxx.xxxx
						With hardware revision xx.0: standard frequency range:		RFQ?			(see description of
						52 MHz to 88 MHz, or 104 MHz to 176 MHz.		RFQ*			arguments)
						With hardware revision xx.1: extended frequency range:		RFQ#
						50 MHz to 90 MHz, or 100 MHz to 180 MHz.
						Use HRV? to obtain the hardware revision level.
						Resolution=100Hz.
						Example: RFQ=072.9872
						Note: The CDM600 supports both 70 and 140 MHz bands.
Rx Interface		RIT=		1 byte, value		Command or Query.		RIT=	RIT?		RIT=x
Type				of 0 thru 6		Rx Interface Type, where:		RIT?			(see description of
						0=RS422		RIT*			arguments)
						1=V.35		RIT#
						2=RS232 (synchronous)
						3=Balanced G.703
						4=Unbalanced G.703
						5=Audio (Data rate is fixed at 64 kbps) (IBS/EDMAC
						only)
						6=LVDS
						Example: RIT=1 (selects V.35)

16–14