Premier Mounts CDM-600 Ret= Ret?, Ret#, Rip= Rip?, Rip#, Edmac EFM=, Efm= Efm?, Efm#, Esa

CDM-600 Satellite Modem						Revision 7
Remote Control						MN/CDM600.IOM
Parameter	Command	Arguments for		Response	Query
	(Instruction	Command or			(Instruction
			Description of Arguments	to		Response to Query
Type	Code and	Response to			Code and
				Command
	Qualifier)	Query			Qualifier)
Receive ESC	RET=	1 byte, 0 or 1	Command or Query. (IDR Parameter)	RET=	RET?	RET=x
Type			Sets or queries IDR ESC Type, where:	RET?
			0=64k data channel	RET*
			1=2 Audio channels	RET#
Rx IF	RIP=	1 byte, value	Command or Query.	RIP=	RIP?	RIP=x
Impedance		of 5 or 7	Rx IF Impedance, where:	RIP?		(see description of
			Ω	RIP*		arguments)
			5=50
			Ω	RIP#
			7=75
			Both Tx and Rx sides will change with this selection.
			Example: RIP=5 (50Ω)
EDMAC	EFM=	1 byte, 0 or 1	Command or Query	EFM=	EFM?	EFM=x
Framing			EDMAC mode, where:	EFM?		(see description of
Mode			0=EDMAC OFF (Idle Mode)	EFM*		arguments)
			1=EDMAC ON (Master Mode)	EFM#
			2=EDMAC ON (Slave Mode, Query Only)
			Example: EFM=1 (EDMAC Enabled as Master)
EDMAC Slave	ESA=	4 bytes	Command or Query	ESA=	ESA?	ESA=xxxx
Address				ESA?		(see description of
Range			EDMAC Slave Address Range - sets the range of	ESA*		arguments)
			addresses of distant-end units (modems or transceivers)	ESA#
			that this unit, as the Master, will forward messages for.
			Only values which are integer multiples of ten are
			permitted. (0010, 0020, 0030, 0040 etc.)
			Example: ESA=0090
			This command is only valid for an EDMAC master.
			When used as a Query, it may be sent to an EDMAC
			slave, which will respond with the appropriate address.

16–21