Premier Mounts CDM-600 specifications Ous?, OUS=xxxxxx, Fsw=

CDM-600 Satellite Modem						Revision 7
Remote Control						MN/CDM600.IOM
Parameter	Command	Arguments for		Response	Query
	(Instruction	Command or			(Instruction
			Description of Arguments	to		Response to Query
Type	Code and	Response to			Code and
				Command
	Qualifier)	Query			Qualifier)
Offline Unit	N/A	6 bytes	Query only. (1:1 set-up)	N/A	OUS?	OUS=xxxxxx
Status			This query is sent to the online modem of a 1:1 pair. It
			provides access to the fault status information (FLT?) of
			the offline modem. This is the only way to interrogate the
			status of an offline modem at the distant-end of a link.
			The response format may be:
			No1for1 which indicates that no 1:1 system has been
			detected. Presence of a 1kHz signal from the CRS-150
			is used to indicate a 1:1 set-up.
			NoComm which indicates that a 1kHz signal has been
			detected, but that there is no (or not yet) a response for
			the modem.
			abcdef would be the FLT? response information from
			the offline unit.
Force 1:1	FSW=	None	Command only.	FSW=	N/A	N/A
Switch				(message
			Forces the unit to toggle the Unit Fail relay to the “fail”	ok)
			state for approx 500ms. If the unit is a 1:1 pair, and it is
			currently the ‘On-Line’ unit, this will force a switchover,
			so the unit will then be in ‘Standby’ mode. The command
			is always executed by the unit, regardless of whether it is
			stand-alone, in a 1:1 pair, or part of a 1:N system.
			This command takes no arguments.

Note: The following codes are used in the ‘Response to Command’ column:

=Message ok

?Received ok, but invalid arguments found

*Message ok, but not permitted in current mode

# Message ok, but unit is not in Remote mode

~ Time out of an EDMAC pass-through message (added in version 1.1.5)

16–38