Premier Mounts CDM-600 29 ODU,ENABLE,STANDALONE KST,CONFIG, 30 ODU,ENABLE,STANDALONE KST,CONFIG

CDM-600 Satellite Modem	Revision 7
ODU Operation	MN/CDM600.IOM

D.2.29 (ODU,ENABLE,STANDALONE KST,CONFIG)				TX
	TX:OFF	FREQ=13955 MHz	ATT=23 dB
			AGC=OFF

Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit the parameter, then press ENTER to implement, or CLEAR.

The user may edit the TX Frequency, the TX Attenuation, the Amplifier setting or the AGC setting.

D.2.30 (ODU,ENABLE,STANDALONE KST,CONFIG)		RX
	RX: FREQ=11950 MHz ATT=20 dB REF=087
	BAND=B

Note: The RX Band is not shown for the KST-2000A.

Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit the parameter, then press ENTER to implement, or CLEAR.

The user may edit the RX Frequency, the RX Attenuation, the Ref setting or the RX Band (KST-2000B only).

D.2.31 (ODU,ENABLE,STANDALONE KST,CONFIG)					MISC
	HPA:OFF	FAULT-LOGIC=SUMMARY
	L NA:OFF	FAULT-LOGIC=SUMMARY		CAL:NO
	Use the [←] or [→] keys to select the parameter to edit. Use the [↑] or [↓] keys to edit
	the parameter, then press ENTER to implement, or CLEAR.
	HPA state		either OFF or ON - HPA power enable
	FAULT-LOGIC		either SUMMARY or NO_SUMMary. This controls whether or not a HPA fault
			will be indicated on the Fault status and will activate the Summary Fault
			Relay.
	LNA state		either OFF or ON - LNA power enable.
	FAULT-LOGIC		either SUMMARY or NO_SUMMary. This controls whether or not a LNA fault
			will be indicated on the Fault status and will activate the Summary Fault
			Relay.
	CAL		To calibrate, select YES and press ENTER. Calibration allows the system to
			determine nominal LNB or LNB power consumption, performed at initial
			installation only. (Default is NO.)

D–14