Premier Mounts CDM-600 specifications Flt?

	CDM-600 Satellite Modem						Revision 7
	Remote Control						MN/CDM600.IOM
Parameter		Command	Arguments for		Response	Query
		(Instruction	Command or			(Instruction
				Description of Arguments	to		Response to Query
Type		Code and	Response to			Code and
					Command
		Qualifier)	Query			Qualifier)
Faults and		N/A	6 bytes	Query only.	N/A	FLT?	FLT=abcdef
				Response is the current fault and status codes, in the form abcdef, where:
Status							(see description for
				a = Unit faults:
				0=No faults			details of arguments
				1=Power supply fault, +5 volts
				2=Power supply fault , +12 volts			e=Change in fault
				3=Power supply fault, –5 volts
				4=Power supply fault, +18 volts			status since last poll.
				5=Power supply fault, –12 volts
				6=Spare			f=Change in unit
				7=Tx synthesizer lock
				8=Rx synthesizer			configuration since
				9=Power cal Checksum error
							last poll.
				A=FPGA main chain load fail
				B=Turbo FPGA load fail
				C=Modem card FPGA load
				D=MUX FPGA load
				E=Demux FPGA load
				F=(Hi-Stab module) No PLL Lock (Note: suppresses TX)
				b = Tx Traffic status:
				0=Tx traffic OK
				1=No clock from terrestrial interface
				2=Tx FIFO slip
				3=AIS detected on incoming data
				4=AUPC upper limit reached
				5= (Hi-Stab module) Ref Activity fault
				c = Rx Traffic status:
				0=Rx Traffic OK
				1=Demodulator unlocked
				2=AGC Alarm - signal out of range
				3=Demux Lock (Frame SYNC)
				4=Spare
				5=Buffer Slip
				6=AIS detected on incoming data
				7=Eb/No alarm
				8=Buffer Clock activity
				d = Open Network:
				0=No Faults
				1=Loss of Tx frame
				2=BER Alarm
				3=Loss of Tx multiframe
				4=Tx signaling AIS
				5=Tx Remote alarm
				6=IBS satellite alarm
				7=IDR Rx BWA1
				8=IDR Rx BWA2
				9=IDR Rx BWA3
				A=IDR Rx BWA4
				B=IDR Tx BWA1
				C=IDR Tx BWA2
				D=IDR Tx BWA3
				E=IDR Tx BWA4
				16–35