Premier Mounts CDM-600 Config Misc HIGH-RATE-ESC, Config Misc WARM-UP, Instant-On,Delay

CDM-600 Satellite Modem	Revision 7
Front Panel Operation	MN/CDM600.IOM

CONFIG: MISC: HIGH-RATE-ESC

HIGH-RATE-ESC = OFF (ON,OFF)

BAUDRATE = 9600 PARITY:DATA:STOP = N81

The ESC type defined here depends on the framing type selected under CONFIG, MODE. The two options are either High-Rate IBS ESC, or ESC++

For units with Firmware Version: 1.3.1 or greater: The High Rate IBS (Engineering Service Channel) is available as a FAST option in conjunction with IBS framing. If enabled, the lower of the TX or RX primary data rate, according to the table below, limits the maximum baud rate. Both TX and RX framing must be IBS to enable this feature.

Data rate	Max ESC baud rate
64 kbps		2400
> 127.999 kbps		4800
> 255.999 kbps		9600
> 383.999 kbps		14400
> 511.999 kbps		19200
> 767.999 kbps		28800
> 1023.999 kbps		38400

For units with Firmware Version: 2.0.1 or greater: ESC++ is available as standard. If enabled, the lower of the TX or RX primary data rate, according to the table below, limits the maximum baud rate. Both TX and RX framing must be set to ESC++. See Chapter 13 for more details on the framing used.

Data rate	Max ESC++ baud rate
>= 64 kbps	4800
>= 128 kbps	9600
>= 192 kbps	14400
>= 256 kbps	19200
>= 384 kbps	28800
>= 512 kbps	38400

CONFIG: MISC: WARM-UP

HIGH-STAB REFERENCE POWER-UP WARM-UP:

NO DELAY(INSTANT-ON) (INSTANT-ON,DELAY)

For units with Firmware Version: 1.4.0 or greater, and with a High-Stability module

installed: The High-Stability Reference Module contains an oven for the crystal. It can take a little time for the oven & crystal to come up to temperature. During this time, the frequency accuracy is not guaranteed. This menu allows the user to select a warm-up delay, which will be implemented on power-up. The delay is calculated by the modem, based on temperature and the amount of time the unit was turned off.

6–25