Make sure nothing rests on the power cord. Do not locate the power cord where people will walk on it. Do not place the power cord under any carpet.

Do not lean or place heavy objects on top of the printer.

For additional requirements, refer to Appendix A.

Check the Power Requirements

WARNING

Do not connect the printer to the power source until instructed to do so and until all shipping restraints have been removed.

WARNUNG

Den Drucker nur unter Anleitung an die Stromquelle anschlieûen, und erst dann, wenn alle Versandmaterialien entfernt worden sind.

ATTENTION

A moins d'en avoir recu l'ordre, ne pas brancher l'imprimante avant d'en avoir ôté tout le matériel d'emballage.

The printer must be connected to an acceptable AC power source; otherwise, the printer will not operate properly and may be damaged. The rear side panel label identifies the correct power source for the printer: either 100 to 120 VAC, 60 Hz or 220 to 240 VAC, 50 Hz.

The power source must be properly grounded. Since large power fluctuations can cause the printer to malfunction, it should be connected to a ªnoise±freeº power source, not subject to surges or noise generated by motors, lighting, or air conditioning equipment on the same circuit. To allow for an adequate power cable run, the printer should be placed no more than eight feet (2.5 meters) from the power outlet.

Setting Up the Printer

2±3

Page 21
Image 21
Printronix L1024 manual Check the Power Requirements