Install the Developer Unit
CAUTION
Perform this procedure only if this is the initial installation and no toner has been added to the developing unit. Otherwise, fill the toner hopper with toner from the toner bottle.
Refer to Figure 2±5 and perform the following steps:
1.Raise the top of the printer by firmly pressing the button on the left of the front panel.
2.Remove the new developer unit from its foil package.
3.Slide the developer unit along the plastic rails on either side of the printer until the developer unit is in position.
4.Lock the developer unit in place by pushing the two green lock±down clamps down until they click.
Developer Unit
Lock±down Clamps
Figure 2±5. Installing the Developer Unit
2±10 | Setting Up the Printer |
