C Media Requirements
The printer requires continuous form electrographic grade media with 0.5 inch pitch tractor feed pin holes. The media capabilities and requirements are listed below:
Width | 4.0 to 10.0 inches edge to edge | |
| (3.5 to 9.5 inches pin to pin) | |
Length | 3.0 to 33.0 inches | |
| in 1/8 or 1/6 inch increments | |
Weight | 18 to 42 lb. bond (67 to 158 g/m2) | |
| 110 lb. tag stock | |
| 99 lb. card stock | |
Labels: |
|
|
Face Stock | 40 to 60 lb. book stock (60 to 90 g/m2) | |
Carrier | 50 lb. book stock (75 g/m2) | |
Adhesive | acrylic | |
Cut to Tie (page perf) | ≥ | 2.9:1 (8 cuts/inch) bond (and microperf) |
| ≥ | 6.5:1 (4 cuts/inch) tag/card stock |
| ≥ 6.5:1 (4 cuts/inch) label stock | |
Percent Recycled paper | 20% maximum | |
Moisture Content | 5% + 1% | |
Resistivity | 108 to 1012 ohms | |
NOTE: Bond paper weight based on 17 X 22 inch base size. Tag stock based on 24 X 36 in base size. Card stock based on 22 1/2 X 28 1/2 inch base size. Book carrier stock based on 25 X 38 inch base size.
Media Requirements | C±1 |
