Connecting the DVD | Other type of connecting |
Recorder | the Video output cable |
1.Disconnect the aerial cable from your TV and
connect it to on the rear panel of the DVD Recorder.
2.Connect of the DVD Recorder and the aerial input of your TV using the supplied aerial cable.
3.Use the Video/Audio Cable to connect ANALOG AUDIO OUT(R/L)/VIDEO OUT jacks on the DVD Recorder to the Audio &Video jacks on the TV.
4.Plug in the DVD Recorder and TV.
5.Turn on the DVD Recorder and TV.
6.Press the INPUT SEL. button on your TV remote control until the Video signal from the DVD Recorder appears on the TV screen.
Wall
DVD Recorder
or or
TV
■ The RF cable connection of this DVD
NOTERecorder sends only signals of TV.
You must connect Audio/Video cables to watch a signal from your DVD Recorder.
■To watch TV programmes, power off the DVD Recorder.
There are several ways to output video signal. Select one of the following video connecting that best suits you below.
●Case 1 : Connecting to a Video (Composite) output jack
●Case 2 : Connecting to an
●Case 3 : Component Video output jacks
●
●Compared to standard interlaced video, progressive scan doubles the amount of video lines fed to your TV, resulting in a more stable,
This is only available with TVs that support progressive scan.
●Progressive Scan Output (576p)
Consumers should note that not all high definition television sets are fully compatible with this DVD Recorder and may cause artifacts to be displayed in the picture, in case of 576 progressive scan picture problems, It is recommended that the user switch the connection to the ‘standard definition’ output. If there are questions regarding our TV set compatibility with this model 576p DVD Recorder, please contact our customer service centre.
English