Samsung DVD-R135/UMG, DVD-R135/HAC manual Setting up the Progressive scan, Dynamic Compression

Dynamic Compression

This is only active when a Dolby Digital signal is detected.

1.On : When Movie soundtracks are played at low volume or from smaller speakers, the system can apply appropriate compression to make low-level content more intelligible and prevent dramatic passages from getting too loud.

2.Off : You can enjoy the movie with the standard Dynamic Range.

NICAM

NICAM programmes are divided into 3 types. NICAM Stereo, NICAM Mono and Bilingual (transmission in another language). NICAM programmes are always accompanied by a standard mono sound broadcast and you can select the desired sound by setting NICAM on or off.

1.On : NICAM mode

2.Off : Only set at this position to record the standard mono sound during a NICAM broadcast if the stereo sound is distorted due to inferior reception conditions.

Setting up the Progressive scan

If the TV supports Progressive Scan, press the P.SCAN button on the front of the DVD Recorder to enjoy.

1 With the DVD Recorder in Stop mode, press the P.SCAN button on the front of the DVD Recorder.

The message “Press [Yes] to confirm Progressive scan mode. Otherwise press [No]” will appear.

Press [Yes] to confirm Progressive scan mode.

Otherwise press [No]

Yes No

2 Press the œ √ buttons to select Yes, and then press the OK button.

3 Set your TV to Progressive input (using the TV remote control.)

System Setup

NOTE

■ When the HDMI cable is connected, this screen is not displayed.

■Do not press the P.SCAN button if you are using a TV that does not support Progressive mode. Nothing will be displayed on the screen if pressed.

■Progressive setting is only available when the DVD Recorder is connected to your TV using component cables.

■If the P.SCAN button on the DVD recorder’s front panel is pressed during playback, the prohibition mark() appears on the screen.

■Progressive setting is only available when the DVD recorder is in stop mode.

English -31