Samsung KFM4GH6Q4M, KFN8GH6Q4M warranty Synchronous WriteRM=1, WM=1, See Timing Diagram 6.6, 6.7

Flex-MuxOneNAND4G(KFM4GH6Q4M-DEBx)
Flex-MuxOneNAND8G(KFN8GH6Q4M-DEBx)
Flex-MuxOneNAND16G(KFKAGH6Q4M-DEBx)	FLASH MEMORY

3.8 Synchronous Write(RM=1, WM=1)

See Timing Diagram 6.6, 6.7 and 6.8

Burst mode operations enable high-speed synchronous read and write operations. Burst operations consist of a multi-clock sequence that must be performed in an ordered fashion. After CE goes low, the address to access is latched on the next rising edge of clk that ADV is low. During this first clock rising edge, WE indicates whether the operation is going to be a read (WE = high) or write (WE = low). The size of a burst can be specified in the BL as either a fixed length or continuous. Fixed-length bursts consist of 4, 8, 16, and 32 words. Continuous burst write has the ability to start at a specified address and burst within the designated DataRAM. The latency count stored in the BRWL defines the number of clock cycles that elapse before the initial data value is transferred between the processor and Flex-MuxOneNAND device. The RDY output will be asserted as soon as a burst is initiated, and will be de-asserted to indicate when data is to be transferred into (or out of) the memory. The processor can access other devices without incurring the timing penalty of the initial latency for a new burst by suspend- ing burst mode. Bursts are suspended by stopping clk. clk can be stopped high or low. Note that the RDY output will continue to be active, and as a result no other devices should directly share the RDY connection to the controller.

To continue the burst sequence, clk is restarted after valid data is available on the bus.

Same as the normal burst mode, the latency is determined by the host based on the BRWL bit setting in the System Configuration 1 Register. The default BRWL is 4 latency cycles. At clock frequencies of 40MHz or lower, latency cycles can be reduced to 3, at frequency range from 40MHz to 66MHz, latency cycle should be over 4. Over clock frequency of 66MHz, latency cycle should be over 6.

For BufferRAMs, both ‘Start Initial Burst Write’ and ‘Burst Write’ is supported. (Refer to Chapter 3.2) However, for Register Access, only ‘Start Initial Burst Write’ is supported. Therefore, Synchronous Burst Write on Register is prohibited.(Refer to Chapter 3.2 and 6.8)

- 71 -