3Unscrew the screw holding the side cover, and then slide the side cover to remove it.

4Unscrew the screw holding the metal shield plate, and then remove the metal shield plate.

5Unpack the SO-DIMM and hold it by the edges.

IMPORTANT

SO-DIMM boards can be damaged by even a small amount of static electricity. Do not touch the memory chips or the board surface. Wear an antistatic wrist strap when you install or remove the board. If you do not have an antistatic wrist strap, keep touching the bare metal on the machine.

Optional accessories

6Hold the SO-DIMM with your fingers on the side edges and your thumb on the back edge. Align the notch on the SO-DIMM with the protrusions with the SO-DIMM slot. (Check that the locks on each side of the DIMM slot are open or facing outwards.)

7Press the SO-DIMM straight into the slot (press firmly). Make sure the locks on each side of the SO-DIMM click into place.

Note

To remove the SO-DIMM, open the retaining clips on both sides of the SO-DIMM by pushing them outward, grasp both edges of the SO-DIMM and pull it out straight.

8Secure the metal plate with the screw.

D

D - 4

Page 156
Image 156
Savin SPC210SF manual Optional accessories